Table of Contents
Calibrating your XNX Honeywell gas detector
This Honeywell article will guide you through the steps required to calibrate your XNX Honeywell gas detector. It includes the EC, mV and infrared sensors and the general status screen. You will also learn how to read the calibration certificate. Here are some tips:
EC sensor type![xnx]()
The Honeywell Analytics XNX Universal Transmitter is a highly flexible gas transmitter that can be used with the full range of Honeywell Analytics gas sensing technologies. It simplifies installation, reduces costs, and provides a single, customizable interface for all gas detection applications. This device is compatible with various types of sensors including EC, mV and IEC sensors.
XNX universal transmitters also support other EC sensors. The EC sensor type is programmable for the exact operating temperature and humidity. The XNX transmitter can also calibrate other sensors for a range of gas and moisture values. There are also methods for configuring alarm levels and settings, such as B. Alarm detection. For further assistance, please visit the XNX Gas Detector Calibration PDF.
infrared sensor type
You must understand the limitations of the sensors you are using to calibrate your XNX Honeywell gas detector. This calibration document will help you determine the range and reach of the sensors you need to install. The calibration process can take anywhere from 30 minutes to an hour. You can download the Calibration PDF file to calibrate your detector. Just make sure to read the instructions carefully. You should only use the calibration page if you are sure your device is properly calibrated.
First you need to determine the type of gas your transmitter is calibrated for. You can find this information on your transmitter. You then need to calibrate the transmitter according to the manufacturer’s instructions. After calibration, you can monitor the gases in the atmosphere. For more information on calibrating your XNX detector, refer to your device manual. To calibrate a sensor, follow the steps outlined below.
General status screen
The XNX Honeywell gas detector must be calibrated to ensure sensor accuracy. This is done in the XNX Universal Transmitter general status screen. The general status screen shows a warning code and an icon indicating gas concentration. Restarts playback when the device is paused or turned off. See the instructions below to learn how to calibrate your XNX Honeywell gas detector.
To calibrate your Honeywell detector, plug it in and follow the instructions on the calibration page. Then turn on the detector. You will be taken to the general status screen where you can check the performance of the sensor. The LCD shows the transmitter status, alarm setpoint and scale. You can also make changes with contactless magnetic switches. To prevent false alarms, the sensor uses an automatic interlock to reduce false alarms on the panel.
Functional Gas Test
You should calibrate your XNX gas detector before you start monitoring hazardous gases. This is critical for safety reasons, as high out-of-range readings can indicate explosive concentrations. To calibrate your detector, you must first reset it and replace the sensor. When the calibration process is complete, the transmitter will ask you to exit and leave it in lock mode.
Zero calibration improves the sensor’s performance and is recommended whenever the detector is used outside of normal operating conditions. However, the confirmatory test is not a reliable calibration method and is intended only as a confidence check. It uses cross sensitivities to test the detector for different gases. On the other hand, crash tests should only be used when a sensor is working properly and is not in critical condition.
To prevent false alarms, the sensor uses an automatic interlock to reduce false alarms on the panel.
